Pulling Eye Lug Duct 14mm-24mm

Pulling eyes designed to install polyethylene ducting using a screw-in tapered thread to grip the inside diameter of the duct. The pulling eyes are typically used to install innerduct inside a larger duct. All are designed with cutting edges to actually cut a thread in the bore of the ducting as it is being screwed in much the same way as using a tap to cut a thread in steel. This helps to ensure a reliable grip. Installation typically requires only 7 or 8 full threads of contact to give a grip stronger than the ducting itself

• Pulling eye lug - sub duct with lug end fitting for direct use with connector swivel
• Pulling eye clevis - tapered threaded sub duct pulling eyes (carrots) with clevis end (requires cabling link for use with connector swivel)